I have been fiddling with chainmail on and off for the past couple years, but I have run into a little issue with the thing I am working on. It started out with me making a small sheet of european 6 in 1, just to see how it looked. I ended up putting it down for a few months, but I just picked it up again and decided I should join the ends and make it into a pouch. So i joined, and now for some reason I just can't figure out how to do the decreases to make the bottom of the pouch. Can someone dumb it down for me? The rings are 18 gauge galvanized steel with an ID of 1/4", if that makes a difference.